Open the Lab →
Made to order
Two ways in. Send files that are ready to manufacture and we run them. Or describe what the thing has to do, and we design it first.
Pick the one that fits
STL, STEP, Gerber or a BOM. We check them for manufacturability, tell you anything that will bite, and print or fabricate directly.
Typically 2–7 working days
No files, just a specification: what it mounts to, what it carries, what it has to survive. We do the CAD or the board design, get it approved, then manufacture it.
Design in 3–10 working days, then manufacture
Indicative rates
Published because a fabrication page without prices loses to any competitor that shows them. All figures are placeholder until confirmed.
| Service | Basis | From | Lead time |
|---|---|---|---|
| 3D printing, FDM | per gram, PLA / PETG / ABS | ₹6 | 2–4 days |
| 3D printing, resin | per gram, standard / tough | ₹14 | 3–5 days |
| PCB, 2 layer | per board, up to 100 × 100 mm | ₹340 | 5–7 days |
| PCB, 4 layer | per board, up to 100 × 100 mm | ₹720 | 7–10 days |
| Assembly, SMT | per joint, after setup | ₹1.40 | +2 days |
| Component sourcing | against your BOM, kitted and labelled | quoted | 3–6 days |
| Design, mechanical or PCB | day rate, minimum half day | on enquiry | scoping in 48 h |
Before you send anything
Set the envelope and the process. The figure updates as you move, and every intermediate number it used is shown so you can see where it came from.
₹0
Placeholder rates (SVC-4). An estimate from a bounding box, not a quote from a file — a real quote needs the geometry, because a thin-walled part and a solid block of the same size do not cost the same.
Before you send
STL or STEP. STEP preferred — it keeps the real dimensions rather than a triangulated approximation.
Gerber RS-274X plus an Excellon drill file, or the native project. Both are fine; the native file lets us fix problems rather than just report them.
CSV or spreadsheet with manufacturer part numbers. Generic descriptions mean we guess, and guessing costs you a revision.
Engineering time
Scoped engagements. You get named engineers, a written proposal, and the source files at handover.
Tell us the problem and the constraint that actually binds — budget, date, weight, cost per unit. One paragraph is enough to start.
Within 48 hours. We work out whether we are the right people, and say so plainly if we are not.
Fixed deliverables, fixed price where the scope allows it, day rate where it genuinely does not. Assumptions listed.
Weekly written updates with whatever is working and whatever is not. No status theatre.
Hardware, source files, firmware and documentation. You can take it to another supplier the next day if you want to.
Start here
Either is fine. If you are not sure which service you need, describe the outcome and we will tell you.